XPS Grooved Tile Backer Board 60cm x 120cm x 20mm

Sold Per Board • 20mm overall thickness (including 3mm cement coating)• Pre-routed for 15mm and 16mm underfloor heating pipe• 150mm pipe centres• High-density 300kPa XPS insulation core• Reinforced cement-coated surface• Lightweight and easy to cut on site• Suitable for solid and suspended timber floors• Panel size: 1200mm x 600mm• Coverage: 0.72m² per board

Warmtoes SQ ‐Wi‐Fi–Pro Thermostat Black (BHT‐1000‐GBLW)

Gain ultimate home climate control with our Warmtoes Wifi Digital Thermostat. Enjoy the convenience of both its compatibility with smart home devices and its feather-touch control, enhanced by the backlit display, 7-day programmability, and built-in air sensor for precise temperature management.  Key Features: Backlit display with feather touch control panel In-built air sensor Wifi compatible (including smart home devices) Economy mode In built low and high temperature protection features NTC floor sensor included Power supply - 230V Maximum load - 16 amps Floor temp between 5°C - 35°C 86x86mm format IP20 class

Warmtoes WHITE SQ ‐Wi‐Fi – Pro Thermostat (BHT‐1000‐GBLW)

Gain ultimate home climate control with our Warmtoes Wifi Digital Thermostat. Enjoy the convenience of both its compatibility with smart home devices and its feather-touch control, enhanced by the backlit display, 7-day programmability, and built-in air sensor for precise temperature management.  Key Features: Backlit display with feather touch control panel In-built air sensor Wifi compatible (including smart home devices) Economy mode In built low and high temperature protection features NTC floor sensor included Power supply - 230V Maximum load - 16 amps Floor temp between 5°C - 35°C 86x86mm format IP20 class

Knauf Aquapanel Floor Tile Underlay 900mm x 1200mm 6mm

Classy kitchen floors with large-size natural stone tiles or comprehensive bathroom refurbishments can also be done on old wooden subfloors. Knauf AQUAPANEL® Cement Board Floor Tile Underlay is a light, highly stable dry floor panel, perfectly suited for ceramic, mosaic or natural stone. As part of the Knauf AQUAPANEL® Cement Board range, it is resistant to water or mildew and thus an ideal solution for wet and humid areas. With a thickness of only 6mm, it makes low floor heights possible as well. • Thickness of only 6mm allowing for increased room height.• Can be installed over existing wooden subfloors.• Will not deteriorate in water.• Resistant to mould and mildew.• Easy to score and snap.• No pre-drilling is required.• Only 9 screws per board are necessary.

Slow Set White Easiflex White 20kg Full Pallet Deal - 54 Bags

This is a full pallet deal for 54 bags   Colour: White Size (kg): 20kg Suitability: Fixing ceramic tiles, mosaics, marble and natural stone to solid impermeable floors and 15mm ply-wood overlay

MAPEBAND PE120 ROLL 10m

TECHNICAL CHARACTERISTICS Mapeband is a vapour and water-resistant rubber tape with fabric edging which is resistant to alkali. Mapeband is elastic and deformable even at low temperatures with excellent resistance to adverse weather conditions. Mapeband is resistant to alkalis, acids and salt solutions (for special cases, test before using). Mapeband is also available in ready-made internal and external corner sections along with Mapeband gaskets for pipes in bathrooms, kitchens, showers, etc. RECOMMENDATIONS For perfect sealing on corners use Mapeband 90° and 270° special corner pieces. For perfect sealing on pipes use Mapeband gaskets. In correspondence with T or cross joints, use the special Mapeband T or Mapeband Cross profiles.   APPLICATION PROCEDURE Apply a thin layer of Mapelastic or Mapelastic Smart, at least 1 mm thick, to the sides of the corners and expansion joints to be waterproofed with Mapeband. Apply the fabric side of the Mapeband tape or special pieces over the fresh layer of Mapelastic or Mapelastic Smart, using a smooth trowel. It is essential that Mapelastic or Mapelastic Smart wet both sides of the Mapeband, also the rubber tape, for a width of several mm. For movement joints (i.e. in terraces) Mapeband must be positioned in the shape of an omega Ω (see overleaf): Mapeband can then be subjected to tension. Joints between Mapeband strips must be sealed with Adesilex T, Adesilex T Super or Adesilex LP. PACKAGING 50 m rolls of 120 mm total width 10 m rolls of 120 mm total width 90° and 270° angles. Gaskets for 120x120-mm and 400x400-mm pipes. 515x315 mm special T profiles. • 515x515 mm special cross profiles.  

MAPEBAND PE120 ROLL 5m

TECHNICAL CHARACTERISTICS Mapeband is a vapour and water-resistant rubber tape with fabric edging which is resistant to alkali. Mapeband is elastic and deformable even at low temperatures with excellent resistance to adverse weather conditions. Mapeband is resistant to alkalis, acids and salt solutions (for special cases, test before using). Mapeband is also available in ready-made internal and external corner sections along with Mapeband gaskets for pipes in bathrooms, kitchens, showers, etc. RECOMMENDATIONS For perfect sealing on corners use Mapeband 90° and 270° special corner pieces. For perfect sealing on pipes use Mapeband gaskets. In correspondence with T or cross joints, use the special Mapeband T or Mapeband Cross profiles.   APPLICATION PROCEDURE Apply a thin layer of Mapelastic or Mapelastic Smart, at least 1 mm thick, to the sides of the corners and expansion joints to be waterproofed with Mapeband. Apply the fabric side of the Mapeband tape or special pieces over the fresh layer of Mapelastic or Mapelastic Smart, using a smooth trowel. It is essential that Mapelastic or Mapelastic Smart wet both sides of the Mapeband, also the rubber tape, for a width of several mm. For movement joints (i.e. in terraces) Mapeband must be positioned in the shape of an omega Ω (see overleaf): Mapeband can then be subjected to tension. Joints between Mapeband strips must be sealed with Adesilex T, Adesilex T Super or Adesilex LP. PACKAGING 50 m rolls of 120 mm total width 10 m rolls of 120 mm total width 90° and 270° angles. Gaskets for 120x120-mm and 400x400-mm pipes. 515x315 mm special T profiles. • 515x515 mm special cross profiles.  

Slow Set White (Easiflex) 20kg

Palace Easi-flex is a standard (slow) setting cement based flexible tile adhesive, shown here in Grey. Use this adhesive to fix to any substrate but especially for use on areas where some movement can occur such as secured plywood, backer-board or timber panels.  This white tile adhesive is ideal for use with light coloured natural stone such as travertine and limestone to prevent shadowing and also for use on whitelight wall or floor tiles to prevent joint overspill showing through joints, also ideal for fixing glass tiles and prevent the adhesive showing through the backing. Easi-flex forms a strong bond with concrete, cement, concrete block-work and brickwork giving improved flexural strength, and also is suitable where under-floor heating is installed. It is sufficiently water-resistant to be suitable for interior / exterior use, in swimming pools and locations which are subject to persistent dampness, e.g. showers, saunas, wet rooms and bathrooms. The manufacturers coverage guidelines state that 20kg will cover approximately 5m2 on a floor, when using a 10mm notched trowel.

Slow Set Grey (Easiflex) 20kg

Palace Easi-flex is a standard (slow) setting cement based flexible tile adhesive, shown here in Grey. Use this adhesive to fix to any substrate but especially for use on areas where some movement can occur such as secured plywood, backer-board or timber panels.  This white tile adhesive is ideal for use with light coloured natural stone such as travertine and limestone to prevent shadowing and also for use on whitelight wall or floor tiles to prevent joint overspill showing through joints, also ideal for fixing glass tiles and prevent the adhesive showing through the backing. Easi-flex forms a strong bond with concrete, cement, concrete block-work and brickwork giving improved flexural strength, and also is suitable where under-floor heating is installed. It is sufficiently water-resistant to be suitable for interior / exterior use, in swimming pools and locations which are subject to persistent dampness, e.g. showers, saunas, wet rooms and bathrooms. The manufacturers coverage guidelines state that 20kg will cover approximately 5m2 on a floor, when using a 10mm notched trowel.